Fujitsu Siemens Computers SPARC Enterprise M8000 - Manual (Page 144)

A-28 SPARC Enterprise Mx000 Servers Dynamic Reconfiguration User’s Guide • September 2007
Invalid parameter.
[Explanation] There is an error in the specified argument or operand.
[Remedy] Confirm the specified argument or operand and execute the command
once again.
Permission denied.
[Explanation] Do not have privilege.
[Remedy] Confirm the user privilege and the command privilege. In the case of
high-end servers, please also confirm whether command is executed by XSCF on
standby side.
A hardware error occurred. Please check the error log for
details.
[Explanation] Hardware error occurred. Please confirm monitoring message and
the error log.
[Remedy] Find out the cause of the DR failure referring monitoring message and
error log. Replace the failure component.
An internal error has occurred. Please contact your system
administrator.
[Explanation] DR failed. There is a possibility that DR failed because of an
internal error in XSCF.
[Remedy] Find out the cause of the DR failure referring monitoring message and
error log. Please also confirm the XCP version.
A.2.3 moveboard
XSB#XX-X will be moved from DomainID X to DomainID X
immediately. Continue? [y|n]:
[Explanation] Confirming whether DR operation is going to be executed or not.
Input "y" to execute it and "n" to stop it.
XSB#XX-X will be assigned to DomainID X immediately. Continue?
[y|n]:
[Explanation] Confirming whether DR operation is going to be executed or not.
Input "y" to execute it and "n" to stop it.
XSB#XX-X will be assigned to DomainID X after DomainID X
restarts. Continue? [y|n]: