Kodak Ektapro Slide Projector 4020 - Manual (Page 12)

Safety Precaution
1 . Do not operate or repair the projector without proper accessories. Add all COVERS before use to
prevent mechanical hazards and electrical shock.
2 . Before operating the projector, check the VOLTAGE SELECTOR. Make sure that the correct line voltage
is selected.
3 . Do not use a damaged POWER CORD. The damaged CORD can cause malfunctions and current
leakage or electrical shock.
4 . If there is any abnormal noise, smell or smoke during operation, deenergize the projector immediately
and contact authorized personal for support.
5 . Do not operate the projector in unsafe locations such as outdoors or in wet places. Do not allow liquids,
gaseous or solid-state materials to enter the projector.
6 . When doing electrical measurements, use an isolation transformer or a leakage current detector in the
power line to avoid an electrical shock.
7 . Use only original parts from the Parts List to repair the projector.
8 . Make sure that the requirements of UL 122 - Splices and Connection - paragraph 13.10 and EN 60 950,
section 4.39 are observed. When replacing AC primary components, such as wires, sockets or capacitors ,
wrap the ends of the wire completely around the terminal before soldering.
Service Manual SM 2547-1
03/98 1-4 Kodak AG, Stuttgart