Powerware 208/120V - Manual (Page 61)

EATON Powerware ® Energy Management System (EMS) Upgrade Kit User’s Guide
S
164201724 Rev 1 www.powerware.com 55
Chapter 5
Maintenance
Keep the area around the hardware and wiring clean and dust-free. Wipe
with a dry cloth as needed. The Energy Management System (EMS)
Upgrade Kit (EMS−UGK) does not require an annual calibration.
Recycling the Used Equipment
Contact your local recycling or hazardous waste center for information
on proper disposal of the used equipment.
C A U T I O N
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper
disposal, contact your local recycling/reuse or hazardous waste center.
Updating the Firmware
To keep the firmware updated with the latest improvements and
benefits, visit www.powerware.com often for updates. You can download
the latest firmware version and the instructions for installing it.
Replacing the Power Xpert Gateway Series 1000 Card
The card can be replaced easily without turning the EMS−UGK off or
disconnecting the load. Follow the instructions included with the card. If
the optional conduit box is installed:
NOTE See Figure 4 on page 12 for the location of conduit box components.
1. Remove the front plate on the right conduit box. Retain the plate
and screws for later reinstallation.
2. Remove the card cover plate at the bottom right of the right conduit
box. Retain the plate and screws for later reinstallation.
3. Follow the instructions included with the card to remove the old
card, replace with the new card, and verify operation.
4. Reinstall the card cover plate and front plate.