Nikon Coolpix S200 - Manual (Page 56)

42
An
ti-s
h
ake Mod
e
Anti-shake Mode
Shooting in Anti-shake Mode
In anti-shake mode, Electronic VR (c 92) and BSS (c 90) are enabled. In
addition, ISO sensitivity is automatically raised to 1000 depending upon the
brightness of the subject and shutter speed is faster than with L (auto)
mode, under the same lighting conditions, to reduce blurring caused by cam-
era shake or subject movement. The flash is disabled. This mode is most
effective when shooting under natural light. Combine it with telephoto
zoom when you are forced to shoot from a distance in order to capture a
fleeting expression on a portrait subject or to photograph an animal without
frightening it off.
1
Press F.
The camera enters anti-shake mode. Press again to
return to the shooting mode selected in the shooting-
mode selection menu.
2
Frame the subject and take the
picture.
Camera focuses on subject in center of
frame.
While the shutter-release button is held
down, camera takes shots to a maxi-
mum of ten, they are compared and
sharpest picture (picture with highest level of detail) is saved.
j
Notes on Anti-shake Mode
• Shutter speed is limited to a certain value for dark subjects.
• Use of the high-sensitivity shooting mode (c 33) is recommended for shooting subjects
under low lighting.
• Pictures taken in this mode may become somewhat grainy.
• Date imprint (c 107) is not available in anti-shake mode.
• Anti-shake mode is not available in panorama assist mode (c 40).
k
Anti-shake Mode Settings
Electronic VR (c 92) and BSS (c 90) are enabled; the flash is disabled. Macro close-up mode
and exposure compensation are available; the self-timer is not available.
l
Image Mode in Anti-shake Mode
When m is pressed in anti-shake mode, adjustment of image mode (c 84) settings is
enabled. Changes made to these settings apply to all shooting modes.
12 12 12