HP Storage Mirroring V5 Software - Manual (Page 240)

A - 4
DTStat
Command DTSTAT
Description Starts the DTStats statistics logging utility from a command prompt.
Syntax DTSTAT [-i < interval >] [-p][-t < filename >] [-f < filename >][-s < filename > < option >]
[-SERVER < ip_address > < port_number >]
Options ‹ -i interval —Refresh from shared memory every interval seconds
‹ -p —Do not print the output to the screen
‹ -t filename —Print to a binary file with the name of filename
‹ -f filename —Reads a previously created DTStat binary file with the name filename
‹ -s filename command —Used with the -f option to read in a previously created DTStat file and
create an ASCII, comma-delimited file. This file can be imported into other software tools like a
spreadsheet. This option can also use one or more of the following options:
‹ - IP address —Filters out the specified IP address in the IP address field and prints only those
entries to the file. Specify more than one IP address by separating them by a comma.
‹ - start time —Only prints connection data to the file after the specified start time . The time
format is mm/dd/yyyy (month/day/year) and hh:mm (hour:minute using the 24 hour clock).
This option can be used in conjunction with the stop option below.
‹ - stop time —Only prints connection data to the file before the specified stop time. The format
is mm/dd/yyyy (month/day/year) and hh:mm (hour:minute using the 24 hour clock). This option
can be used in conjunction with the start option above.
‹ SERVER ip_address port_number —Connects DTStat to the specified IP address using the
specified port number instead of to the local machine
Examples ‹ DTStat
‹ DTStat -i 30
‹ DTStat -p -i 5 -t dtstats.log
‹ DTStat -f stat.log
‹ DTStat -f statistic.sts -s dtstat.log -start 02/02/2000 09:25
‹ DTStat -server 206.31.4.51 1106
Notes ‹ This command is not case-sensitive.
‹ If no options are specified, DTStat will print the output to the screen at an interval of every
second.
‹ The IP address, start, and stop options can be used simultaneously in the same -s command.
‹ If the statistics are not changing, DTStat will discontinue writing until statistics begin updating
again.
‹ File names that contain non-alphanumeric characters must be enclosed in quotation marks.