HP Storage Mirroring V5 Software - Manual (Page 55)

HP StorageWorks Storage Mirroring Application Manager user’s guide 45
After you select the Identity Failover option, click Configure . The Configure Identity Failover window will appear.
Enter the following information for Identity failover:
• Source IP —Select the source IP address(es) to be monitored for failover.
• Target NIC —Select the target NIC to be used when failover occurs.
• Target IP Addresses —This area displays the IP address(es) of the selected target NIC.
• IP Address — (Default = selected) Select the IP Address checkbox if you want the specified source IP address
to be monitored.
If you are in a WAN environment and choose
Identity Failover , you should NOT failover the IP address.
• Server Name — (Default = selected) Select the Server Name checkbox if you want the source name to be
added to the target when failover occurs.
• Shares — (Default = selected) Select the Shares checkbox if you want the source file shares to be added to
the target when failover occurs.
• Active Directory Hostname (SPNs) —This option will automatically remove the host SPN (Service Principle
Name) from Active Directory for the source and add it to Active Directory for the target during failover.
After the Identity failover configuration is complete, click OK to save your entries and return to the Configure
Protection window.
Services
Storage Mirroring Application Manager will determine the appropriate SQL services to start/stop based on
your operating system/SQL configuration. You should only modify this selection if there are additional services
that need to be started along with SQL during the failover/failback process.
Modifying the default configuration for services may affect whether data can be successfully replicated.
Do not
modify the services to start/stop unless you are very familiar with Storage Mirroring and SQL.
To add a service, click
Add . In the Add Service window, select the Service name from the drop-down box, then
click Add . Alternately, you can manually enter a service, then press Enter . By default, most services must be
stopped on the target for replication to occur properly. When you are finished entering services, click Add to
return to the Failover configuration window.