Troubleshooting, Solving common problems, Appendix a troubleshooting – HP LP2065 20-inch LCD Monitor User Manual
Page 38: Atroubleshooting
A
Troubleshooting
Solving Common Problems
The following table lists possible problems, the possible cause of each problem, and the recommended
solutions.
Problem
Possible Cause
Solution
Screen is blank.
Power cord is disconnected.
Connect the power cord.
Power switch on front panel of the
monitor is turned off.
Press the front panel power button.
Master power switch on rear panel
of the monitor is turned Off.
Turn the master power switch to On.
Video cable is improperly
connected.
Connect the video cable properly. Refer to Chapter 3,
Setting Up the Monitor on page 5
for more information.
Screen blanking is active.
Press any key on the keyboard or move the mouse to
inactivate the screen blanking utility.
Image appears blurred,
indistinct, or too dark.
Brightness and contrast are too low. Press the
—/Auto
button on the front panel. If this does not
correct the image, press the
Menu
button to open the Basic
OSD Menu, and adjust the brightness and contrast scales
as needed.
Image is not centered
Position may need adjustment.
Press the
Menu
button to access the OSD menu. Select
Image Control/Horizontal Position
or
Vertical Position
to
adjust the horizontal or vertical position of the image.
Check Video Cable is
displayed on screen.
Monitor video cable is
disconnected.
Connect the DVI-D signal cable to the DVI-I connector on
the computer, or the VGA to DVI-I cable to the DVI-I
connector on the computer. Be sure that the computer
power is off while connecting the video cable.
Out of Range. Set Monitor
to 1280 × 1024 @ 60Hz is
displayed on screen.
(LP1965 19" model)
Video resolution and/or refresh rate
are set higher than what the monitor
supports.
Restart the computer and enter Safe Mode. Change the
settings to a supported setting (see
Model Factory Preset Modes on page 35
). Restart the
computer so that the new settings take effect.
Out of Range. Set Monitor
to 1600 × 1200 @ 60Hz is
displayed on screen.
(LP2065 20" model)
Video resolution and/or refresh rate
are set higher than what the monitor
supports.
Restart the computer and enter Safe Mode. Change the
settings to a supported setting (see
Model Factory Preset Modes on page 35
). Restart the
computer so that the new settings take effect.
Out of Range. Set Monitor
to 1920 × 1200 @ 60Hz is
displayed on screen.
(LP2465 24" model)
Video resolution and/or refresh rate
are set higher than what the monitor
supports.
Restart the computer and enter Safe Mode. Change the
settings to a supported setting (see
Model Factory Preset Modes on page 36
). Restart the
computer so that the new settings take effect.
30
Appendix A Troubleshooting
ENWW