INFICON TM-400 Thin Film Deposition Monitor User Manual
Page 80
11 - 4
IP
N 17
88
0
0 Re
v.
B
TM-350/400 Operating Manual
11.4 Troubleshooting Aids To Isolate Installation Faults
The following table describes possible problems that could occur when interfacing
the Monitor with a vacuum system. With each symptom is a list of probable causes.
If you should decide to remove the Monitor cover, read
and
carefully before doing so.
WARNING - Risk Of Electric Shock
To avoid electrical shock or personal injury, disconnect
the power cord before opening the cover on the power
entry module.
WARNING - Risk Of Electric Shock
Do NOT use the power switch as a disconnecting device;
disconnect the power cord from the power entry module
to fully remove hazardous voltage from inside the TM
monitor.
WARNING - Risk Of Electric Shock
All standard safety procedures associated with the safe
handling of electrical equipment must be observed. Only
properly trained personnel should attempt to service the
instrument.