Pure Elan DX40 - Manual (Page 10)

8
Changing your radio setup
The following options are available in DAB, FM or both.
Backlight
Choose whether the screen backlight is on, off, or turns on when a button is pressed, both
when the unit is on (Active) and in Standby.
Audio settings
FM stereo mode
Choose from Stereo or Mono - mono may be clearer for stations with weak signals.
DRC value
DRC (Dynamic Range Control) value makes the quieter sounds in a DAB broadcast easier to
hear at low volume or in a noisy environment.
Check with the broadcasters to find out if they use DRC.
DRC full
Applies the DRC level as sent with the broadcast.
DRC half DRC level is set to half that sent with the broadcast.
DRC off Any DRC level broadcast will be ignored.
Station order
Alphanumeric Lists all stations in alphanumeric order.
Active station Lists active stations first on the station list.
Multiplex Lists stations in groups according to their multiplex.
Trim stn. list Removes inactive stations from the station list.
Tuning
Autotune
Scans all DAB Band III frequencies for stations and adds any new ones to the station list. To
stop an Autotune press Select.
Manual tune
Shows DAB signal level which can help you find the best position for your radio.
1.
Use the +/- buttons to scroll through different channels and push Select to choose one
(UK stations are in the range 11B to 12D). You see a signal level display. The empty
block indicates the minimum required level for reception and the filled blocks indicate
the current level.
2. Move your aerial and try to raise the current level to the empty block or beyond. Once
you have a good signal the display will show the multiplex name and add the stations to
the station list.
3. Push the Menu button to exit or +/- and Select buttons to change channel.