Bulb replacement, Headlamps, Fog lamps – Jeep 2012 Patriot - Owner Manual User Manual

Page 455: Rear tail, turn signal and backup lamps

Advertising
background image

BULB REPLACEMENT

Headlamps

1. Raise the hood and locate the connector behind the
headlamp.

2. Reach into engine compartment and pull red lock out
at connector.

3. Remove the green connector from the back of the bulb
by pulling straight back.

4. Twist the bulb to the left.

5. Pull bulb outward from assembly.

NOTE:

These are halogen bulbs. Take care not to touch

the bulb with your fingers. Body oils from your fingers
could cause excessive heat buildup which reduces bulb
life.

Fog Lamps
Refer to the Service Manual or see your authorized dealer
for bulb replacement.

CAUTION!

Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with any oily surface, clean the
bulb with rubbing alcohol.

Rear Tail, Turn Signal And Backup Lamps

1. Raise the liftgate.

2. Remove the two push-pins from the taillamp housing.

3. Grasp the taillamp and pull firmly to disengage the
light from the aperture panel.

4. Twist and remove socket from the light.

5. Remove bulb from socket and replace.

7

MAINTAINING YOUR VEHICLE

453

Advertising
This manual is related to the following products: