Wireless > wireless security, Advanced configuration, Wireless security – Linksys WRT160NL User Manual
Page 16
![background image](/manuals/76740/16/background.png)
Chapter 3
Advanced Configuration
12
Wireless-N Broadband Router with Storage Link
After the client device has been configured, click
3.
OK. Then refer back to your client device or its
documentation for further instructions.
Method #3
Use this method if your client device asks for the Router’s
PIN number.
Enter the PIN number listed on this screen. (It is also
1.
listed on the label on the bottom of the Router.)
After the client device has been configured, click
2.
OK. Then refer back to your client device or its
documentation for further instructions.
The Wi-Fi Protected Setup Status, Network Name (SSID),
Security, Encryption, and Passphrase are displayed at the
bottom of the screen.
NOTE:
If you have client devices that do not
support Wi-Fi Protected Setup, note the wireless
settings, and then manually configure those
client devices.
Wireless > Wireless Security
The Wireless Security screen configures the security of
your wireless network. There are six wireless security
mode options supported by the Router: WPA Personal,
WPA Enterprise, WPA2 Personal, WPA2 Enterprise, RADIUS,
and WEP. (WPA stands for Wi-Fi Protected Access, which
is a security standard stronger than WEP encryption. WEP
stands for Wired Equivalent Privacy, while RADIUS stands
for Remote Authentication Dial-In User Service.) These
six are briefly discussed here. For detailed instructions
on configuring wireless security for the Router, refer to
Chapter 2: Wireless Security Checklist, page 3.
Wireless Security
Security Mode
Select the security method for your wireless network. If
you do not want to use wireless security, keep the default,
Disabled.
WPA Personal
NOTE:
If you are using WPA, then each device in
your wireless network MUST use the same WPA
method and shared key, or else the network will
not function properly.
Security Mode > WPA Personal
Encryption
WPA supports two encryption methods, TKIP
and AES, with dynamic encryption keys. Select the type of
algorithm, TKIP or AES. The default is TKIP.
Passphrase
Enter a Passphrase of 8-63 characters.
Key Renewal
Enter a Key Renewal period, which instructs
the Router how often it should change the encryption
keys. The default is 3600 seconds.
WPA2 Personal
Security Mode > WPA2 Personal
Encryption
WPA2 supports two encryption methods,
TKIP and AES, with dynamic encryption keys. Select the
type of algorithm, AES or TKIP or AES. The default is TKIP
or AES.
Passphrase
Enter a Passphrase of 8-63 characters.
Key Renewal
Enter a Key Renewal period, which instructs
the Router how often it should change the encryption
keys. The default is 3600 seconds.