Dimplex DS7420 - Manual (Page 4)

4 www.dimplex.com
OPERATION - DS7420 MOD A - D
To access the controls, go to the back of the stove. (Figure
3)
A. MAIN POWER ON/OFF SWITCH
The main power on/off switch supplies power to all stove
functions (heater & flame).
B. TOP LIgHT ON/OFF SWITCH
Controls the light intensity of the log bed display area.
C. HEATER ON/OFF SWITCH
The heater on off switch supplies power to the heater.
D. HEATER THERMOSTAT CONTROL
To adjust the temperature to your individual requirements,
turn the thermostat control clockwise all the way to turn
on the heater. When the room reaches the desired tem-
perature, turn the thermostat knob counter clockwise until
you hear a click. Leave in this position to maintain the
room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will
turn on.
RESETTINg THE TEMPERATURE CUTOFF SWITCH
Should the heater overheat, an automatic cut out will turn
the heater off and it will not come back on without be-
ing reset. It can be reset by switching the MAIN ON/OFF
SWITCH to OFF and waiting 5 minutes before switching
the unit back on.
CAUTION: If you need to continuously reset the heater,
unplug the unit and call Dimplex North America Limited
at 1-800-668-6663.
REMOTE CONTROL
The remote control has a range of approximately 50ft.
(15.25m) it does not have to be pointed at the stove and
can pass through most obstacles (including walls). It is
supplied with one of 243 independent frequencies to pre-
vent interference with other units. The frequency designa-
tion is indicated on the back of the transmitter (Figure 4)
REMOTE CONTROL INSTALLATION
Plug stove cordset into the outlet located on the side of 1.
the receiver. (Figure 4)
Plug receiver into the wall outlet.
2.
Install a 9 volt battery into the transmitter. (Figure 4) 3.
! NOTE:
Stove MAIN on/off switch must be in the ON position •
prior to using the Remote Control.
ON/OFF Remote Control may be used to control most
•
other electrical devices including T.v.’s, stereos and
lamps.
CAUTION:
For indoor use in dry areas only •
For use on electrical devices with 15 amp resistive load •
or 1/3 HP inductive load
120 volt AC only
•
A
B
C
D
Figure 3
Receiver
Outlet
OPEN
OPEN
Frequency
Code
Battery
Cover
Figure 4