Document Outline

• EDS700ACBA
  • Contents
  • About this documentation
    • Document history
    • Conventions used
    • Terms and abbreviations used
    • Notes used
  • Safety instructions
    • General safety and application notes for Lenze controllers
    • General safety and application instructions for Lenze motors
    • Residual hazards
  • Product description
    • Device features
    • Overview of the devices
      • Supply modules
      • Axis modules
    • Identification
    • Product key
  • Technical data
    • General data and operating conditions
    • Rated data
      • External supply voltage 24 V
      • Busbar system for the DC bus
      • Supply modules
      • Axis modules
    • Overcurrent operation
      • Supply modules
      • Axis modules
    • Terminal description
      • Supply modules
      • Axis modules
  • Mechanical installation
    • Important notes
    • Drilling the holes into the mounting plate
    • Dimensions
      • Devices with standard built-in design
      • Assembly in standard built-in technique
      • Devices with "cold plate" design
      • Mounting in "cold plate" technique
      • Devices with push-through design
      • Assembly in push-through technique (thermal separation)
    • Notes on mounting the device version in push-through design
  • Electrical installation
    • Important notes
      • Electrical isolation
      • Device protection
      • Motor protection
      • Interaction with compensation equipment
    • Safety instructions for the installation according to UL
    • Installation according to EMC (installation of a CE-typical drive system)
      • Shielding
      • Mains connection, DC supply
      • Motor cable
      • Installation in the control cabinet
      • Wiring outside of the control cabinet
      • Detecting and eliminating EMC interferences
    • Measures when drive is used in IT systems
    • Preparations
      • Integrated PE conductor connection
      • Integrated DC bus connection
    • Power supply modules
    • Axis modules
  • DC-bus operation
    • Introduction
      • Terminology and abbreviations used
      • Advantages of a drive system
    • Conditions for trouble-free DC-bus operation
      • Voltages
      • Number of feeding points
      • Other conditions
    • DC-bus variants
      • Supply with one power supply module
      • Supply with power supply modules operated in parallel
      • Supply with regenerative power supply module
    • Rated data
      • General data
      • DC-supply power
      • DC-power requirements
    • Basic dimensioning
      • General information
      • Power distribution of controllers
      • Motor efficiency
      • Power loss of devices
      • Determining the power requirements
      • Determining the regenerative power requirements
      • Cable protection
    • Braking operation in a drive system
      • Basic considerations
    • EMC in DC-bus operation
      • Compliance with EMC category C3 (industrial premises)
      • Compliance with EMC category C2 (residential areas)
      • Assignment of filters
  • Commissioning
    • Before switching on
    • Quick commissioning
  • Diagnostics
    • Display of operating data, diagnostics
      • Supply modules
      • Axis modules
    • LED status displays
      • Supply modules
      • Axis modules
  • Safety engineering
    • Introduction
    • Important notes
      • Hazard and risk analysis
      • Standards
      • Mission time
    • Acceptance
      • Description
      • Periodic inspections
    • Basics for safety sensors
    • Operating mode
      • Introduction
    • Technical data
    • Electrical installation
    • Certification
  • Accessories (overview)
    • Overview
    • Mains chokes
    • RFI filter/mains filter
    • External brake resistors
    • Power supply units
    • Terminals
    • Components for operation in the DC-bus connection
    • Installation material for the push-through technique
    • EMC accessories
      • Shield mounting
  • Appendix
    • Total index
  • ©