GSW JWF307 - Manual (Page 2)

– 2 –
Thank you for purchasing this water heater. Properly
installed and maintained, it will provide years of trouble free
service. This manual gives instructions for the proper instal-
lation, safe operation and maintenance of this water heater.
It is your responsibility to ensure that your water heater is
properly installed and cared for.
John Wood Oil Fired Water Heaters are designed to supply
domestic hot water for normal residential demands. Any
deviation from this could affect your warranty.
Important Consumer Notice
The warranty on this water heater is in effect only when the
water heater is installed and operated in accordance with
these instructions. The manufacturer of this water heater will
not assume any liability for any property damage or person-
al injury resulting from failure to comply with these instruc-
tions.
Protect your warranty: Regularly service your water heater
as directed in the “Maintenance” section of this manual.
Installation Code Requirements
In addition to the installation instructions found in this man-
ual, the water heater must be installed in accordance with all
local and provincial or state codes or, in the absence of local
and provincial or state codes, with the latest editions of:
“Installation Code for Oil-Burning Equipment (CSA
B139-04)” and
“Canadian Electrical Code Part 1 (C22.1)” (in Canada)
available from:
Canadian Standards Association,
5060 Spectrum Way,
Mississauga, Ontario, Canada
L4W 5N6
or
“Standard for the Installation of Oil-Burning Equipment
(NFPA 31)” and
“National Electrical Code (NFPA 70)” (in USA) available
from:
American National Standards Institute,
25 West 43rd Street,
New York, NY 10036
Important: Installation and service of an oil fired water
heater and burner must be performed by a qualified Oil-
Burner Technician to comply with local and provincial or
state codes applicable to this type of equipment. All supply
equipment, installation, approvals, permits, inspections, etc.
are the responsibility of the owner of this water heater.
Consult your local authorities for regulations specific to your
area.
Your safety and the safety of others is very important.
We have provided many important safety messages in this manual and on your appliance.
Always read and obey all safety messages.
All safety messages will tell you what the potential hazard is, tell you how to reduce the
chance of injury, and tell you what can happen if the instructions are not followed.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word
“DANGER” or “WARNING”.
DANGER
WARNING
You can be killed or seriously injured if you don’t immediately follow
instructions.
You can be killed or seriously injured if you don’t follow instructions.
I) INTRODUCTION
IMPORTANT:
This water heater must be installed strictly in accordance
with the instructions enclosed, and local electrical, fuel
and building codes. It is possible that connections to the
water heater, or the water heater itself, may develop
leaks. IT IS THEREFORE IMPERATIVE that the water
heater be installed so that any leakage of the tank or relat-
ed water piping is directed to an adequate drain in such a
manner that it cannot damage the building, furniture, floor
covering, adjacent areas, lower floors of the structure or
other property subject to water damage. This is particular-
ly important if the water heater is installed in a multi-story
building, on finished flooring or carpeted surfaces. GSW
WILL NOT ASSUME ANY LIABILITY for damage caused
by water leaking from the water heater, pressure relief
valve, or related fittings. Select a location as centralized
within the piping system as possible. In any location
selected, it is recommended that a suitable drain pan be
installed under the water heater. This pan must limit the
water level to a MAXIMUM depth of 45mm (1 3/4 in.) and
have a diameter that is a minimum of 50mm (2 in.) greater
than the diameter of the water heater. Suitable piping shall
connect the drain pan to a properly operating floor drain.
When used with a fuel-fired heater, this drain pan must not
restrict combustion air flow.