Perle Systems DS1 - Manual (Page 63)

63
Configuring Users
Configuring Line Access
Line Access defines the read/write privileges that a user has while accessing a line.
Configure the following options:
Line Access
Language
You can specify whether a user will use English or Customlang as the
language that appears in the Menu, CLI, or WebManager. The Device Server
supports one custom language that must be downloaded to the Device Server;
otherwise, Customlang defaults to English.
Service
The type of service that the user will use.
Host IP
When the User Service is set to Telnet or TCP_clear , the target host IP
address. If 255.255.255.255 is specified in the configuration, the user will be
prompted for an IP address or hostname. If no IP address is specified, the Host
IP value in the Default User configuration will be used. The default is 0.0.0.0 .
TCP Port
When the User Service is Telnet , this is the target port number. The default
value will change based on the type of Service selected; the most common
known port numbers are used as the default values.
Specifies the user access rights to each Device Server device line. Options are:
z Read/Write—Users are given read and write access to the line.
z Read In—Users are given access to read only outbound data, data that is
going from the Device Server to the device.
z Read Out—Users are given access to read only inbound data, data that is
going from the device to the Device Server.
Users can read data going in both directions by selecting both the Read In and
Read Out options.