Nostalgia Electrics SLUSHEASE HSM-245 - Manual (Page 6)

7
7. Remove the aluminum cylinder from the plastic auger cage and lift
off the cap on the aluminum cylinder. (You may need to use the cap
opener located on the back of the unit under the motor.)
8. Now parts are all ready to wash in warm soapy water, towel dry.
USING YOUR HOME SLUSHEASE MACHINE™
1. Fill aluminum ice cylinder with small or broken pieces of ice. Be sure
to fill both sides of the aluminum cylinder equally. Do not fill past Fill
Line. NEVER attempt to remove the divider in the cylinder.
NOTE: For best results use crushed ice or small pieces of ice.
2. Add 7 tablespoons (4 oz) of table salt. Add 2 to 4 teaspoons (20 ml)
of room temperature water. (THIS IS VERY IMPORTANT TO THE
FREEZING OF BEVERAGES).
3. Place the lid back on the aluminum canister. (Make sure the lid is on
tight and secure). See A below.
4. Place aluminum cylinder into the auger cage so that the lid of
the aluminum canister is facing toward the top of lid as shown
in picture B below.
5. Place cage lid on cage, making sure the teeth are aligned
properly to lock into place. You may need to turn it so that the
teeth align properly.
A
B
6. Place assembled cylinder cage into the
blue mixing chamber. (Make sure to align
grooves and notches for the cage to fit
correctly into the blue mixing chamber.)
8
7. You may need to rotate the cylinder
cage slightly to enable the cylinder cage
to drop down into the mixing chamber.
8. Push both front and back end plugs
into cylinder cage, to lock into mixing
chamber.
Illustration A Illustration B
9. After positioning the blue mixing chamber onto motor base (see
Illustration A) you may need to rotate the cylinder cage while
pushing the mixing chamber back toward the motor, so they lock in
to place and are fitted correctly (see Illustration B).
10. Once the unit is together, lock the mixing chamber into the unit.
Levers Unlocked Levers Locked
11. Place lid back onto mixing chamber, make
sure, lid is locked at the spout end with tabs
and at the motor end with lid clip. UNIT WILL
NOT OPERATE WITH THE LID OFF, AS
A SAFETY SHUT OFF.
Front End Plug