Neuton CE 6.2 - Manual (Page 40)

36 1-866-NEUTON1 (638-8661) www.neutonpower.com
Cleaning Your Mower
Periodically clean your Mower to ensure peak performance.
BEFORE PERFORMING THE FOLLOWING CLEANING PROCEDURES, REMOVE THE SAFETY KEY AND BATTERY
TO PREVENT ACCIDENTAL STARTING.
Supplies Needed:
• Clean, damp cloth or sponge
•
Mild soap or detergent (if needed)
•
Soft nylon brush (if needed)
1. Using a damp cloth or sponge with a mild soap or detergent, clean the Mower. Never use water,
gasoline, solvents, or other petroleum-based or solvent-based products when cleaning –
remember that this is an electric Mower.
2. Use a soft nylon brush or non-metallic scrubbing pad to remove any clippings that have
accumulated on the underside of the Deck and in the Side Discharge Chute. Do not use a wire
brush; it will scratch and harm the surface of your Mower.
3. You may use water to clean the Rear Bagger when not attached to the Mower. For proper grass
collection, make sure the Bagger is clean and the mesh holes are unclogged. Allow the Rear
Bagger to dry thoroughly before using it again.
NOTE: A wet Rear Bagger will clog quickly and hamper grass collection.
Cleaning the Handlebar
Remember to clean and lubricate the Handlebar on your Mower at least once a year or whenever
grime builds up on the sliding parts of the Handlebar.
BEFORE PERFORMING THE FOLLOWING CLEANING PROCEDURES, REMOVE THE SAFETY KEY AND BATTERY
TO PREVENT ACCIDENTAL STARTING.
Supplies Needed:
•
Clean cloth or paper towel
• WD-40® or similar lubricant