Tyan Computer Transport GS10 B2094T15 - Manual (Page 45)

45
http://www.TYAN.com
6.4 Adding a CD Drive (for test purpose)
In case you need to use a CD drive with your system, follow this procedure.
WARNING: You are advised not to make frequent connection and disconnection on the
IDE connector as this might cause damage to the data cable and connector pins.
CAUTION: Follow the instructions in this section carefully. The DVD or CD drive contains a
laser device. Do not attempt to open the DVD or CD drive’s enclosure or remove a DVD or
CD drive using any procedures other than those contained in this section to avoid the risk of
exposure to harmful radiation.
With a Secondary Hard Disk Drive Installed
1. Remove the cabinet cover (see section 6.1).
2. Unplug the data cable and power cord from the rear of the secondary hard disk drive. Unplug
the other end of the data cable from the secondary IDE connector on the system board.
3. Use the three-heade d power cable that came with your system and connect the single end to
the previously unplugged power cord (Œ) from step 2. Connect the remaining two ends of the
power cable, one to the rear of the secondary hard disk drive (•) and the other to the rear of
the CD drive (Ž).
4. Use the three-heade d data cable that came with your system and connect the single end to the
secondary IDE connector (Œ). Connect the remaining two ends of the data cable, one to the
rear of the secondary hard disk drive (•) and the other end to the rear of the CD drive (Ž).
Three-headed power
cable