Uniden DECT1580 Series - Manual (Page 45)

44 44 45 45
Setting Up the
Answering System Setting the Number of Rings
The.ring.time.setting.allows.you.to.set.the.number.of.rings.the.caller.hears.before.your.answering.system.plays.the.
outgoing.message..You.can.set.the.ring.time.to.answer.after.two,.four,.or.six.rings..If.you.enable.the.Toll.Saver.(TS).
setting,.the.answering.system.picks.up.after.two.rings.if.you.have.new.messages,.and.after.four.rings.if.there.are.
none..This.way,.if.you.make.a.long.distance.call.to.check.your.messages,.you.can.hang.up.after.the.third.ring.to.
avoid.long.distance.billing.charges.
Press.MENU/SELECT..
Select.the.Ans. Setup.menu,.and.then.the.Ring Time.submenu.
Move.the.cursor.to.select.a.ring.time.(Toll Saver,.2.Times,.4.Times,.or.6.Times).
Press.MENU/SELECT. You will hear a confirmation tone.
Setting the Record Time (or Announce only)
You.can.choose.how.long.callers.have.to.record.a.message..Set.the.record.time.to.1.Minute.or.4.Minutes.to.limit.the.
time.for.incoming.messages..If.you.set.the.record.time.to.Announce Only,.the.answering.system.answers.the.call.but.
prevents.callers.from.leaving.a.message.
Press.MENU/SELECT..
Select.the.Ans. Setup.menu,.and.then.the.Record Time.submenu.
Move.the.cursor.to.select.a.record.time.(1 Minute,.4.Minutes,.or.Announce Only).
Press.MENU/SELECT. You will hear a confirmation tone.
While.your.answering.system.is.set.to.Announce Only,.the. message counter.LED.on.the.base.displays.“A.”.If.you.
are.using.the.prerecorded.greeting,.the.system.automatically.switches.to.the.following.message:.“Hello,.no.one.is.
available.to.take.your.call..Please.call.again.”.If.you.are.using.a.personal.greeting,.the.system.continues.to.use.that.
greeting.
1)
)
3)
4)
1)
)
3)
4)