Velleman CTC1000 - Manual (Page 11)

CTC1000
V. 01 – 12/06/2013 11 ©Velleman nv
2. Press OK again.
7.6 Duress Code
Use
 Can be used to arm or disarm the alarm system.
 Entering the code when under duress from an assailant triggers a silent alarm and
sends a secret message to the programmed mobile phones.
 No siren will sound for duress alarm.
Default value  Not set
Properties  4 digits
 Optional
 Will be cleared when resetting the system (see chapter System reset)
To set a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Key in a 4 digit code and press OK.
3. Repeat the code and press OK.
To change a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Press .
3. Key in a 4 digit code and press OK.
4. Repeat the code and press OK.
To delete a duress code
1. To access the menu item: enter Program mode, go to Gen. Settings, select Duress Code and press OK.
2. Press OK again.
7.7 Master Code
Use
 Required together with the pin code to enter the device‟s Program mode.
Default value  1111
Properties  4 digits
 Mandatory
 Cannot be deleted
 Will be reset to default when resetting the system (see chapter System reset)
 The master code needs to be different from the pin codes