Velleman CTC1000 - Manual (Page 23)

CTC1000
V. 01 – 12/06/2013 23 ©Velleman nv
1. Use the up and down arrows to select a device and press OK.
You can now change the device attribute. To skip this step, press .
2. Use the up and down arrows to select an attribute and press OK.
3. Press OK to confirm.
You can now change the device name. To skip this step, press . To continue, press OK.
4. Enter a zone name and press OK.
The display returns to the device list. Use the up and down arrows to select another device or press .
Edit a remote keypad – water sensor
1. Enter Program mode, go to Devices+/-, select Edit devices and press OK.
The display lists all the devices available.
2. You can now change the device name.
3. Enter a zone name and press OK.
The display returns to the device list. Use the up and down arrows to select another device or press .
9.5 Remove a device
1. Enter Program mode, go to Devices+/-, select Remove device and press OK.
The system lists all available devices.
2. Use the up and down arrows to select a device and press OK.
For details about the available working modes, see section 9.3.