Roadi RDT51 - Manual (Page 121)

OWNER S MANUAL
,
OBD2 Car Scanner
117
CHECK
This Drive Cycle…
=======================
Diagnostic Menu.…
====================6/11
MIL Status OFF
Misfire Monitor
OK
Fuel System Mon OK
Comp. Component OK
Catalyst Mon INC
Htd Catalyst N/A
5) If the vehicle supports readiness test of “This Drive Cycle”, a screen of
the following displays:
6) Press
ESC button to return to Diagnostic Menu.
11.6 O2 Monitor Test
OBD2 regulations set by SAE require that relevant vehicles monitor and
test the oxygen (O2) sensors to identify problems related to fuel efficiency
and vehicle emissions. These tests are not on-demand tests and they are
done automatically when engine operating conditions are within specified
limits. These test results are saved in the on-board computer's memory.
The O2 Monitor Test function allows retrieval and viewing of O2
sensor monitor test results for the most recently performed tests from the
vehicle's on-board computer.
The O2 Monitor Test function is not supported by vehicles which
communicate using a controller area network (CAN). For O2 Monitor Test
results of CAN-equi pped vehicles, see chapter" On-Board Mon. Test”".
1) Use
UP/DOWN scroll button to select O2 Monitor Test from
Diagnostic Menu and press ENTER button.
Read Codes
Erase Codes
Live Data
View Freeze Frame
I/M Readiness
O2 Monitor Test