Flyzone FLZA3342 - Manual (Page 9)

9
Fit the battery in place in the battery compartment. Turn on
the transmitter with the throttle all the way down to the idle
position. Connect the battery to the ESC.
Attach the canopy hatch being sure that the battery leads and
servo leads are not interfering with the hatch.
Moving the right stick down will cause the elevons to move up.
Moving the right stick to the left will cause the left elevon to
move up and the right elevon to move down.
If the elevons do not move together when the right stick is
moved up or down, the elevon mixing function is not turned
on in your transmitter. If you are using the TTX404 transmitter,
disconnect the battery from the ESC and turn off the transmitter.
Hold the left stick down and to the left and the right stick down
and to the right. While holding the sticks in this position, turn
on the transmitter. The transmitter will make one, two, or three
consecutive beeps indicating the mode it is in. 1 beep- NORMAL
MODE, 2 beeps- V-TAIL MODE, 3 beeps- ELEVON MODE.
Each time the power is cycled on with the sticks in this position
the transmitter will change mode. Repeat this process until it
beeps three times for elevon mode.
These are the control surface throws
as they are set up from the factory:
If using a transmitter with the Tactic AnyLink ™ , set up as above.
AILER
ON
ELEV
A
TOR
3/8"
[ 9.5mm]
3/8"
[ 9.5mm]
3/8"
[ 9.5mm]
3/8"
[ 9.5mm]
Up
Up
Down
Down