Philips NORELCO CC5060 - Manual (Page 8)

Cleaning
I Clean the attachments after each use.
¥
Always switch Clipper OFF. unplug and remove
power supply cord from Clipper before
cleaning.
I Do not use compressed air. abrasive cleaning
agents, scourers or liquids such as alcohol,
benzene, bleach or acetone to clean the
Clipper and attachments.
> Never clean, replace or remove Clipper
attachments with motor ON.
I Never rinse or immerse the Clipper handle in
water or any other liquid.
I Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this
may damage them.
I Use a soft, dry cloth to clean Clipper handle.
During Use:
¥
If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or
using cleaning brush provided. Remember to
adjust the clipping length back to your selected
setting where you replace the comb on Clipper.
After Each Use:
o
Make sure the Clipper is switched OFF
and disconnected from the electrical outlet
B Remove the hair comb attachment by
pressing the Hair Length Selector (1) and
sliding the comb off the Clipper (2) (fig. 8).
B Push the center top end of the cutter
blade upwards with your thumb until it
opens (fig. 9).
□ Clean the cutting unit with the cleaning brush
supplied (fig. 10).
B Clean the inside of the Clipper with the
brush supplied (fig. 11).
□ Clean the handle, combs and the adaptor
with the cleaning brush supplied or with
a dry cloth.
B
Close the cutting unit until it'clicks’ into
place.