Sears 113.21308 - Manual (Page 10)

assembly
WARNING: FOR YOUR OWN SAFETY, NEVER CON­
NECT PLUG TO POWER SOURCE OUTLET UNTIL
ALL ASSEMBLY STEPS ARE COMPLETED.
---- TOOLS NEEDED
[ ' I ' I ' I ' I ' I ' M I I I ' I
1 . i , i .
I . I
^
COMBINATION SQUARE
FRAMING SQUARE MUST BE TRUE.
Check its accuracy as illustrated below.
DRAW LIGHT STRAIGHT EDGE OF
LINE ON BOARD BOARD 3/4" THICK-
ALONG THIS EDGE s. . THIS EDGE MUST BE
£ PERFECTLY STRAIGHT
MEDIUM
SCREWDRIVER
8-INCH ADJUSTABLE
WRENCH SHOULD BE NO GAP OR OVERLAP WHEN
SQUARE IS FLIPPED OVER IN DOTTED POSITION
o ...............
8mm DIA. x 20mm LONG BOLT
ASSEMBLY OF BASE/COLUMN
1. Position base on floor. Remove protective covering
and discard.
2. Remove protective sleeve from column tube and
discard. Place column assembly on base, and align
holes in column support with holes in base.
3. Locate three (3) 8mm Dia. x 20mm long bolts
among loose parts bag.
4. Install a bolt in each hole through column support
and base and tighten with adjustable wrench.
INSTALLATION OF TABLE/SUPPORT
ASSEMBLY AND HARDWARE
1. Locate tabie/support assembly
2. Slide tabie/support assembly onto column. Position
directly above base.
10