Ditch Witch JT30AT - Manual (Page 85)

Prepare - 85
JT30 /JT30 All Terrain Operator’s Manual
Prepare Jobsite
CMW
Prepare Jobsite
Mark Bore Path
Mark your planned bore path and all located utility lines with flags or paint.
Prepare Entry Point
For bore to be successful, first pipe must be straight as
it enters the ground. “Align the Joints” on page 154.
To help ensure that the first pipe does not bend, dig a
small starting hole so that the first pipe is drilled into a
vertical surface. Steer down as required at start. Drill
head will tend to move in easiest direction (toward
surface) when rotated near the surface.
To prevent bending or straining pipe, position drilling
unit for straight entry.
Jobsite hazards could cause death or serious injury. Use
correct equipment and work methods. Use and maintain proper safety
equipment.
To help avoid injury:
• Classify jobsite as electric if jobsite classification is in question or if the possibility of unmarked
electric utilities exists.
• Expose lines by hand before digging. Cutting high voltage cable can cause electrocution.
• Remove all vegetation near operator’s station. Contact with trees, shrubs, or weeds during electrical
strike could result in electrocution.