SMA SB 240 - Manual (Page 24)

Procedure:
1. Keep the supplied mounting overview at hand for the allocation of the inverters to the PV
modules.
2. In case the connection area points upwards during mounting, make sure to protect the plugs
and pin connectors against ingress of moisture.
3. Remove the label with the inverter serial number from the inverter and attach it to the
corresponding position in the mounting overview included in the delivery.
4. Insert the T-head bolts into the profile rail and
turn by 90°. This will firmly anchor the screws in
the profile rail.
5. Position the inverter on the anchored screws.
Insert the screws into the oblong holes in the
enclosure as far as the required fastening point.
6. Attach the inverter using suitable washers and
nuts.
7. Ensure that the inverter is securely in place.
5.2.2 Mounting the Inverter on the Wall
To mount the inverter on the wall, proceed as follows.
Additionally required mounting material (not included in the scope of delivery):
☐ The mounting material must be made of stainless steel.
☐ Two screws suitable for the support surface
☐ Two washers suitable for the screws
☐ Two screw anchors suitable for the support surface and the screws
5 Mounting SMA Solar Technology AG
Installation Manual SMA-SB240-IA-en-12 24