SMA SI 3.0-11 - Manual (Page 21)

SMA Solar Technology AG 5 Operation of the Sunny Island Inverter With the Sunny Remote Control
Operating Manual SI30M-44M-60H-80H-BE-en-30 21
5 Operation of the Sunny Island Inverter With the Sunny Remote Control
5.1 Display Modes
The Sunny Remote Control uses four display modes for the display. The Sunny Remote Control will switch to standard
mode if the button has not been used for over five minutes.
The parameters for devices that are not configured are hidden, e.g., the generator parameters are hidden for systems
without a generator. The parameters for multicluster systems are only available in expert mode.
Mode Page content
Standard mode
<home>
• Message regarding operating states
• Display of energy flows
• Display of key parameters
In display messages on the Sunny Remote Control, <home> refers to the standard mode.
User mode
User
• Display of and access to key operating parameters
In display messages on the Sunny Remote Control, User refers to the user mode.
Installer mode
Installer
• Display of and access to configuration and operation parameters
The installer mode is protected with an installer password. In display messages on the
Sunny Remote Control, Installer refers to the installer mode.
Expert mode
Expert
• Display of and access to all parameters for the system configuration set in QCG
The expert mode can only be accessed via installer mode (see Section 5.4.1, page 29). In display
messages on the Sunny Remote Control, Expert refers to the expert mode.