DCS Owner's Guide - Manual (Page 16)

14
INSTALLATION
CAVITY DIMENSIONS
BE1-48R BE1-36R
Inches (mm) Inches (mm)
A Maximum height of enclosure shell 35 1/2" (902) 35 1/2" (902)
B Depth of enclosure shell 22 3/4" (578) 22 3/4" (578)
C Minimum depth for hood swing 3 3/4" (95) 3 3/4" (95)
D Width of enclosure cavity 51 5/8" (1318) 40 1/2" (1029)
E Height of enclosure cavity 11 1/8"(283) 11 1/8"(283)
f Depth to gas supply opening 18 1/2"(464) 18 1/2"(464)
G Height to base of vents 1" (25) 1" (25)
H Height of opening for access doors/drawers 20" (508) 20" (508)
I Width of opening for access doors/drawers 46" (1168) 34" (864)
ACCESS DOORS
MODEL NUMBER ACCESS DRAWERS
MODEL NUMBER
CAVITY WIDTH CAVITY HEIGHT
Inches (mm) Inches (mm)
ADN1-20x48 ADR2-48 46" (1168) 20" (508)
ADN1-20x36 ADR2-36 34" (864) 20" (508)
ADN1-20x30 ADR2-30 28" (711) 20" (508)
ADN1-20x24 ADR2-24 22" (559) 20" (508)
D
E
H
I
G
F
A
B
C
Built-in Construction Details
Standard layout for cavity including insulated jacket
Note: vents are to be located at the left,
right and rear of the enclosure. Minimum
size of all vents is 10x10" (645mm x 645mm)
Note: the cut-out of each
corner should be a 90°angle
in order for the access doors/
drawers to fit properly.
Note: 4x4” (102mm x 102mm)
opening for gas supply line
FIG. 06
To order access drawers or doors, please visit www.dcsappliances.com for further details.