Furuno LCD DISPLAY MU-155C - Manual (Page 19)

12
Display
unit ID
3.4 Remote Controller Setting
A remote controller can be set to be operative with a specific display unit, in the case of
multiple MU-155C display units. Set the remote controller mode desired on the SYSTEM
menu as follows;
1. Press the [MENU] key to show the main menu.
2. Press the [►] key to select SYSTEM.
SYSTEM menu
3. Select INFRARED REMOTE.
4. Point the remote controller toward the display unit, and press any key on the remote
controller. The current setting of remote controller is shown inside the remote controller
setting square.
5. Press the [RGB2] and [BRILL +] keys together on the remote controller to change the
remote controller ID among A, B, C and D.
Your selection appears inside the square.
6. Press the [◄] or [►] key so that the display unit ID is the same as the remote controller
ID in the square.
7. Press the [MENU] key to close the menu.
Remote controller ID square
RGB1 RGB2 DVI VIDEO1 VIDEO2 VIDEO3 OSD SYSTEM
INFRARED REMOTE A
DEFAULT RESET NO
INFORMATION
RGB1 : 1280x1024 fH: 80KHz fV: 75Hz
RGB2 : 640x480
fH: 31KHz fV: 60Hz
DVI : NO SIGNAL
VIDEO1: NTSC
VIDEO2: PAL
VIDEO3: NO SIGNAL
PROGRAM NO. *****