FRIGIDAIRE 800 Series - Manual (Page 14)

14
Solutions to Common Dishwashing Problems
(continued)
Dishwasher Has an Odor
• Soiled dishes left in dishwasher too long can
create an odor. Rinse dishes if not running
dishwasher at once.
• There will be a "new" smell when first installed.
This is normal.
• Check to see if unit is draining properly. (See
Dishwasher Does Not Drain Properly.)
Status Lights Flashing
• When first installed or when power has been
interrupted, HI-TEMP WASH and NO HEAT
DRY status lights will flash. To clear, press the
START/CANCEL pad. If power failure occurs
during a cycle, it will be necessary to restart
the dishwasher by resetting the cycle you
want.
Stains on Tub Interior
• Washing large amounts of dishware with
tomato based soil can cause a pink/orange
appearance. This will not affect performance
and will gradually fade over time. Pre-rinsing
will reduce the chance of staining. Using No
Heat Dry option will lessen staining.
Removing Spots and Film
Hard water can cause lime deposit buildup on
the interior of the dishwasher. Dishes and glasses
may also get spots and film for a number of
reasons. (See Glassware/Flatware Spotted or
Cloudy section.) To remove buildup, spots and
film, clean using the following instructions:
1. Load clean dishes and glasses in normal
manner. Do not load any metal utensils or
silverware.
2. Do not add detergent.
3. Select the POTS PANS cycle. Close and latch
door. Press START/CANCEL pad.
4. Allow dishwasher to run for 25 minutes to
reach the main wash portion of cycle.
5. Unlatch and open door and pour 2 cups of
white vinegar into the bottom of dishwasher.
6. Close and latch door. Press START/CANCEL
pad and allow cycle to finish.
Note: If these conditions persist, a home water
softener should be considered.
Dishwasher Leaks
• Use only fresh detergent designed for
automatic dishwashers. Measure detergent
carefully. Try a different brand.
• Spilled rinse aid can cause foam and lead to
overflowing. Wipe up any spills with a damp
cloth.
• Check to see that dishwasher is level. (See
Installation Instructions.)
Normal Sounds You Will Hear
• Normal sounds include water fill, water
circulation and motor sounds.
• There is a noticeable change in sound when
the wash action switches between the lower
and middle spray arm. This is normal since
each spray arm has its own sound.
• It is normal for dishwasher to pause (no
sound) when the wash action is switching
between the lower and middle spray arms.
Water in Bottom of Tub
• Water left in bottom of tub after cycle is
complete is not normal. If water remains in
the bottom of the tub, dishwasher may not be
draining properly. (See Dishwasher Does Not
Drain Properly.)
Dishwasher Won't Run
• Check to see if circuit breaker is tripped or if a
fuse is blown.
• Make sure water supply is turned on.
• Check to see if cycle is set correctly. (See
Operating Instructions.)
• Is dishwasher set for delay start option?
• Make sure door is closed and latched.
Dishwasher Does Not Drain Properly
• If unit is hooked up to a food waste disposer,
make sure the disposer is empty.
• Check to see if the knockout plug has been
removed from inside the food waste disposer
inlet.
• Check to see if drain hose is kinked.
• Make sure cycle is complete, not in a pause.
Cycle Takes a Long Time
• Is cycle in a water heating delay?
• Has the delay start option been selected?
Dishwasher Won't Fill
• Is water supply turned on?
• Does overfill protector move up and down
freely? (See Overfill Protector section.)