GE DV-354 - Manual (Page 14)

Connecting Up
Important
l
Before unplugging the player from the
power outlet, make sure you first switch
it into standby using either the front
panel STANDBY/ON button, or the
remote control, and wait of the
message to disappear from the player’s
display.
. For the above reasons, do not plug this
player into a switched power supply
found on some amplifiers and AV
receivers.
Using other types of video
output
This player has standard (composite),
Video and component video outputs. The
main difference between them is the quality
of the
S-Video delivers a better
picture than standard composite video, while
component video gives better picture quality
still. The variety of outputs also gives you the
flexibility of connecting your particular
equipment using the best connection type
available.
Connecting using an S-Video
output
You can use the S-Video output instead of the
VIDEO OUT jack to connect this player to
your TV (or other equipment).
1 Use an S-Video cable (not supplied)
to connect the S-VIDEO OUT to an
S-Video input on your TV, monitor or
AV receiver.
Line up the small triangle above the jack
with the same mark on the plug before
plugging in.
Connecting using the component
video output
You can use the component
instead of the VIDEO OUT jack to connect
this player to your TV (or other equipment).
1 Use a component video cable (not
supplied) to connect the COMPONENT
VIDEO OUT jacks to a component video
input on your TV, monitor or AV receiver.
E n