Maintenance and servicing, 9b. adjusting door catch riva cube, 9a. adjusting door catch riva avanti – Stovax RVF40AVM User Manual

Page 16

Advertising
background image

16

MAINTENANCE and SERVICING

8.3

Squeeze a generous bead of fresh Thermic Seal glue into

the rope locating groove. Do not glue over the screw

heads. Press the new rope into the locating groove, placing

the joint in the middle of the lower edge of the door.

8.4

Refit the door and close the door to apply pressure to new

rope. Leave the appliance closed for at least 6 hours before

lighting and using at a low output for approximately one

day.

8.5

Using the Riva stove with a damaged door seal could cause

dangerous fumes to enter the room, or the appliance to

overfire, resulting in damage.

8.6

If you require help your local dealer will be able to

carry-out all of your service and maintenance requirements

for a reasonable cost.

(Tool required - 13mm A/F spanner)

9.1

To maintain the safe use of your Riva stove, you may need

to adjust the door catch to ensure safe correct closing of the

door. Complete this operating as follows

9.2

Open the door to give access to the fixed part of the door

catch as shown.

9.3

Using a 13mm A/F spanner loosen the locking nut holding

the catch block shown in diagram 11, and reposition to

achieve the correct fit. This may need a trial and error

approch to find the correct position.

9.4

If the door still feels loose after correcting the catch

operation, the door rope seal is worn and requires

replacement, as detailed in section 8.

9.1

To maintain the safe use of your Riva stove, you may need

to adjust the door catch to ensure safe correct closing of the

door. Complete this operating as follows

9.2

Open the door to give access to the fixed part of the door

catch as shown.

9.3

Using a 4mm A/F hexagon head key (supplied) loosen the 2

fixing screws, as shown, and reposition the catch block to

achieve the correct fit. This may need a trial and error

approch to find the correct position.

9.4

If the door still feels loose after correcting the catch

operation, the door rope seal is worn and requires

replacement, as detailed in section 7 of the Users

Instructions.

9B. ADJUSTING DOOR CATCH

RIVA CUBE

PR7104

PR7103

Fixing Screw

4mm Hex Key

9A. ADJUSTING DOOR CATCH

RIVA AVANTI

PR7176

PR7177

Advertising