Global Machinery Company REDEYE DB305SMS - Manual (Page 13)

13
Turning on and off
1. To turn the saw on depress
and hold the on/off trigger
switch (24) (fig. S).
2. To turn the saw off release
the on/off trigger switch (24).
Turning on the
REDEYE® laser line
generator
The REDEYE® laser line
generator emits 2 intense
narrow beams of pure red
light to guide you as you cut.
It improves operator cutting
vision, enables faster set-up,
increases accuracy and improves safety. To turn on the
laser lines press the laser light on/off switch (2) (fig. T).
To turn off the laser press the laser light on/off switch (2)
one more time.
Setting the table
square with the blade
1. Make sure that the
electrical plug is removed
from the power point.
2. Push the saw arm (5)
down to its lowest position
and engage the release
knob (6) to hold the saw
arm in the transport position.
3. Loosen the mitre lock (25) (fig. U).
4. Rotate the table (21) until the pointer is positioned
at 0º.
5. Tighten the mitre lock (25).
6. Loosen the bevel lock (16)
and set the saw arm (5) at
0º bevel (the blade at 90º
to the mitre table). Tighten
the bevel lock (16) (fig. V).
7. Place a set square against
the table (21) and the flat
part of the blade. (fig. W)
Note. Make sure that the
square contacts the flat part
of the saw blade, not the
teeth.
8. Rotate the blade by hand
and check the blade-to-
table alignment at several
points.
9. The edge of the set square
and the saw blade should be parallel.
10. If the saw blade angles away from the set square,
adjust as follows.
11. Use a 13mm wrench
or adjustable wrench
to loosen the lock nut
securing the 0° bevel
adjustment screw (35)
(fig. X). Also, loosen the
bevel lock (16).
S
T
U
V
W
X
90°