Marantz MV8300 - Manual (Page 76)

76
EN
ATTENTION
● This VCR contains microcomputers. External electronic noise or interference can cause microcomputer to
malfunction. If the VCR does not operate correctly switch its power off and unplug the AC power cord from the
AC supply. Wait for a while and then plug the power back in. Eject and check the condition of the cassette. If
everything appears normal, you can operate the VCR as usual.
● MARANTZ EXPRESSLY DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, AND SHALL NOT BE LIABLE
FOR ANY AND ALL DAMAGES, CLAIMS OR LIABILITIES, DIRECT OR INDIRECT, ARISING FROM OR
RELATING TO THE USE OF THIS PRODUCT WITH ANY OTHER PRODUCT, DEVICE, COMPONENT, PART
OR MATERIAL THAT IS NON-CONFORMING OR NON-COMPATIBLE WITH THIS PRODUCT.
● THE i.LINK/DV CONNECTION OF THIS PRODUCT CONFORMS TO IEC61883-1; IEC61883-2; IEC61883-4;
IEEE STD 1394-1995; IEEE STD 1394A-2000; 1394 INTERFACE IMPLEMENTATION GUIDELINE FOR D-VHS
VERSION 1.00 AND DTCP (DIGITAL TRANSMISSION CONTENT PROTECTION) SPECIFICATION VERSION
1.1
(THE “SPECIFICATIONS”). USE OF THIS PRODUCT WITH ANOTHER PRODUCT, DEVICE, COMPONENT,
PART OR MATERIAL THAT IS NOT IN CONFORMITY OR COMPLIANT WITH THE SPECIFICATIONS, OR
THAT IMPLEMENT THE SPECIFICATIONS IN A NON-CONFORMING OR NON-COMPATIBLE MANNER WITH
THIS PRODUCT, MAY NOT BE SUPPORTED AND MAY CAUSE DAMAGE TO OR MALFUNCTION OF THIS
PRODUCT. ANY USE OF THIS PRODUCT WITH A NON-CONFORMING OR NON-COMPATIBLE PRODUCT,
DEVICE, COMPONENT, PART OR OTHER MATERIAL SHALL BE AT THE USER’S SOLE AND EXCLUSIVE RISK.
MOISTURE CONDENSATION
Moisture in the air will condense on the VCR when you move it from a cold place to a warm place, or under
extremely humid conditions—just as water droplets form on the surface of a glass filled with cold liquid. Moisture
condensation on the head drum will cause damage to the tape. In conditions where condensation may occur, keep the
VCR turned on for a few hours to evaporate the moisture before inserting a tape.
ABOUT HEAD CLEANING
Accumulation of dirt and other particles on the video heads may cause the playback picture to become blurred or
interrupted. Be sure to contact your Marantz authorized dealer if such troubles occur.
CORRECTIVE ACTION
If you need the skipped channels,
restore them (
੬
pg. 14).
Press PAUSE ( 8 ) to pause the
recording, change channels, then
press PLAY (
3 ) to resume recording.
Reset the correct brand codes
(
੬
pg. 68 – 70 ).
Select a different host channel during
Semiauto Clock Set (
੬
pg. 11), or
perform Manual Clock Set (
੬
pg. 12).
Unplug the AC power plug once, then
plug it again.
Set it to off.
SYMPTOM
1. When scanning channels, some of
them are skipped over.
2. The channel cannot be changed.
3. The Remote will not operate your
TV or cable box or DBS receiver.
4. Even though Auto or Semiauto
Clock Set has been performed, the
clock is incorrect.
5. “PM” blinks on the front display
panel.
6. The subtitles and the menu screen
are overlapped.
POSSIBLE CAUSE
● Those channels have been preset to
be skipped.
● Recording is in progress.
● The brand codes are set incorrectly.
● The clock setting data received from
the host channel is incorrect.
● The VCR do not work properly.
● The subtitle display on the TV is set
to on.
OTHER PROBLEMS
TROUBLESHOOTING (cont.)
MV8300_U1B-EN72-88 4/1/3, 2:28 PM 76