Moxi 3012 - Manual (Page 16)

Use and program the remote
16
Program the remote
Before you begin, find the codes for your TV from the table starting on
page 62. Write them here:
____________________________________________________________
____________________________________________________________
____________________________________________________________
If you have an audio receiver, find the codes in the table starting on
page 67. Write them here:
____________________________________________________________
____________________________________________________________
____________________________________________________________
Use one of the following procedures:
• Programming with codes
• Programming by search on page 16 — use this if your brand is
not listed or if the given codes do not work.
Programming with codes
Program the Moxi remote to control TV power and volume, as well as
power, volume, and mute for an audio device.
1. I n front of the TV, press and hold the Moxi and OK buttons simulta-
neously on the Moxi remote, until the LED at the top of the remote
blinks twice.
2. Using the number buttons on the remote, enter one of the codes for
your device that you wrote down or from the reference tables start-
ing on page 61. When you enter a code correctly, the LED blinks
twice. If it blinks once, the code was invalid—try entering the code
again. If the code was correct for your device, then the device
responds automatically (turns on or off).
3. If the TV or device does not respond, start over using another listed
code. Repeat until successful, or see Programming by search on
page 16.
Programming by search
If the TV or audio device is not listed, or the codes listed do not work,
try programming by search. Programming by search allows the remote
to cycle through codes to find one that works with the TV or audio
device.
Some older devices may not be supported. If the device fails to
respond to any code, use its original remote to control it.