Marvel Industries Refrigerated Drawers 80RDE - Manual (Page 8)

TROUBLESHOOTING YOUR REFRIGERATED DRAWERS
7
Before Calling for Service
Before calling for service, check the troubleshooting table on this page. This
table lists possible problems that you can remedy without difficulty to avoid an
unnecessary service call.
PROBLEM POSSIBLE CAUSES/SOLUTIONS
Odor in cabinet 1. Interior needs cleaning
Noisy operation
1. Cabinet not level
2. Weak floor
Cabinet vibrates
1. Cabinet not level
2. Weak floor
Cabinet light not working
1. Tube burned out
2. No power at outlet
Appliance will not run
1. “ON/OFF” button pressed
2. Power cord not plugged in
3. No power at electrical outlet
4. House fuse blown
Appliance runs too long
1. Prolonged door openings
2. Control set too cold
3. Condenser needs cleaning
Moisture collects inside
1. Too many door openings
2. Prolonged door openings
3. Hot, humid weather increases condensation
4. Control improperly set
Moisture collects on out-
side surface
1. Hot, humid weather increases condensation
(as humidity decreases, moisture will disap-
pear)
2. Control improperly set
Interior too hot/too cold 1. Control improperly set
Sentry System™
refrigeration monitor
activated
1. See “Warning Alarms” on page 3
2. See “Sentry System™ Control Quick
Reference”
3. Temperature alarm may occur after user se-
lected temeprature set point changes in excess
of 10 degrees F, or during heavy usage condi-
tions. This is normal and not a fault of the
appliance. The Sentry System™ is monitoring
the duration of large swings in temperature to
protect your contents, and may alert you to this
event. See “Reset Alarms” on page 4.