Marantz MV8300_U1B - Manual (Page 22)

22
EN
IN F-1
+
C
B
Basic
Playback
Features Checking tape position
The tape position indicator
appears on the screen in the
following cases:
● When you change the VCR
operation mode from the
stop mode to fast forward
or rewind mode.
● When you perform an
Index Search ( ੬ pg. 24).
The position of “ ” in relation to “B” (Beginning) or “E”
(End) shows you where you are on the tape.
NOTES:
● “SUPERIMPOSE” must be set to “ON”, or the indicator will
not appear (
੬ pg. 57).
● It may take a few seconds for the tape position indicator to be
displayed.
To reset the time counter, press C. RESET on the
Remote. The counter reading becomes “0:00:00”. It is
also reset when a tape is inserted.
Playing back tape repeatedly
— Repeat Playback
You can play back a tape repeatedly (50 times).
While playing back a tape, press and hold PLAY ( 3 )
for more than 5 seconds.
The play indicator (
# ) on the front display panel starts
flashing slowly, and a tape will be played back 50 times.
To stop playback, press STOP (
7 ) on the Remote or
STOP/EJECT ( 7 / 0 ) on the front panel.
NOTE:
For a cassette recorded in D-VHS mode, Repeat Playback is not
possible if the cassette was recorded in LS3 or LS5 mode.
B
BASIC PLAYBACK AND RECORDING (cont.)
A
B E
● Turn on the VCR and the TV, and select the AV
mode on the TV.
● Set the VCR/TV/CABLE/DBS selector on the
Remote to “VCR”.
VCR
TV
CABLE
/DBS
D
C
B
HM-DH40000U-EN21-33 1/22/3, 4:37 PM 22