Multiquip Stow Submersible Pump SS-233 - Manual (Page 10)

PAGE 10 — STOW SS-233 SUBMERSIBLE PUMP — OPERATION MANUAL — REV. #2 (05/03/04)
STOW SS-233 SUBMERSIBLE PUMP
—
COMPONENTS
Figures 1 shows the location of the basic components, for the
STOW Model SS-233 submersible pump. Listed below is a brief
explanation of each component.
1. AC Power Cable – This unit is supplied with a 20 ft. (6.1
meters) AC power cable. Always check the cable for signs
of wear. NEVER! use a defective power cable. Replace the
cable immediately if the cable is worn or defective.
2. 2-Inch NPT Fitting – Install this fitting into the discharge
port of the pump
3. Discharge Port – Connect a 2" NPT hose to this port.
Remember to adequately support the discharge hose to
avoid stress on the pump.
4. Thermal Overload Protection – This pump has an internal
thermal overload protection device that will shut-down the
motor in the event of high operating temperatures. The motor
will automatically restart once the temperature returns to
an acceptable operating temperature.
Figure 1. Submersible Pump Components
5. Strainer Base – This strainer base is made of durable
plastic. DO NOT pump large objects or debris with this
pump. This pump is for pumping water only. For de-watering
purposes, always place the strainer base on a platform.
6. Electric Motor – This unit utilizes a single-phase, 115 V,
0.5 HP electric motor. Consult with a licenced electrician
before connecting motor to a power source. Observe all
city and local safety codes.
7. Volute/Impeller – Impellers are constructed of thermo
plastic to minimizes wear and prolong service life.