ioSafe R4 - Manual (Page 72)

P/N: 900-10004-00 REV 02 USER GUIDE, IOSAFE R4 72
► S N M P
If you utilize a SNMP management system such as HP OpenView or CA UniCenter to monitor
devices on your network, you can set up the ioSafe R4 device to work within this infrastructure.
To set up SNMP service, check the Enable SNMP service checkbox in the SNMP tab. You can
leave the Community name as public, or specify a private name if you have opted for a more
segregated monitoring scheme.
Next, enter a host name or an IP address for Trap destination. This is where all trap messages will
be sent. The following system events will generate a trap:
ƒ Abnormal power voltage
ƒ Abnormal board enclosure temperature
ƒ Fan failure
ƒ UPS connected
ƒ UPS detected power failure
ƒ RAID disk sync started and finished
ƒ RAID disk added, removed, and failure
ƒ Snapshot invalidated
If you wish to limit SNMP access to only a secure list of hosts, specify the hosts in the Hosts
allowed access field.
Click Apply to save your settings.
When you have saved the SNMP settings on the ioSafe R4, you can import the ioSafe SNMP MIB
to your SNMP client application. The ioSafe MIB can be from the ioSafe Support site at
http://www.iosafe.com.