iHome iHC5 - Manual (Page 10)

7
Using the iHC5 Replacing the Remote Control Battery
The remote control battery is already installed at the factory. When the remote control
stops operating or its range seems reduced, it is time to replace the battery.
1. The battery door is located on the back end of the remote.
2. Pull the battery door to release the battery door latch.
3. Insert a CR2032 battery, checking that the + and – sides of the battery match the drawing
inside the battery compartment.
4. Replace the battery door into the remote control.
Note: Make sure you dispose of batteries properly (see your local regulations).
For best results, aim remote control towards the remote sensor on the lower left corner of
the display.
Battery Door
Replacing Clock Backup Battery
The iHC5 uses a backup battery system (3 pre-installed AA
batteries) to provide continuous alarm operation and clock settings
in the event of a power failure. If the backup battery has been
installed and a power failure occurs or the AC cord is accidentally
disconnected, the display backlight will not remain lit, but current
time and alarm time settings will be temporarily maintained.
Otherwise, you must reset the time and alarm settings.
NOTE: Please make sure the AC adaptor is connected. Otherwise
all settings may be lost during battery replacement.
1. Open the backup battery compartment door located on the
bottom of the unit.
2. Insert 3 AA batteries, checking that the polarity (+ and – ends of
the battery) matches the drawing near the battery compartment.
3. Close the compartment door.
Note: Make sure you dispose of batteries properly (see your local regulations).
Replace Backup Battery



P10