IBM 07N2230 - Manual (Page 9)

P/N: 55P5776
9
Fig. 7 Connection of the converter signal cable and the monitor
Connect the other end (marked "3") of the converter signal cable (07N2229) to the converter box.
Fig. 8 Connection of the converter signal cable and the converter box
Connect the dual-link signal cable (55P5729) to the converter box.
It is only necessary to connect the USB cable (55P5728) to the converter box if you wish to use the
monitor's Color Management Utility or Firmware Update Utility. In this case, the program(s) for
either or both of those utilities must be installed prior to connecting the USB cable.
Note:
The video input and video output are Safety Extra Low Voltage (SELV) circuits.
Converter signal cable (07N2229)
Cable hook
Cable clamp
Important:
Do not connect the USB cable unless you are using the Color Management Utility or Firmware
Update Utility.