Invacare WALKING TUTOR WT 200 User Manual
Safety summary, Assembling the walking tutor
1
For more information regarding Invacare products, parts, and services,
please visit www.invacare.com
Walking Tutor
Model No. WT 200
NOTE: Check all parts for shipping damage. In case of damage, DO NOT use. Contact
Carrier/Invacare for further instructions.
Safety Summary
To ensure the safe and proper installation of the WT200 walking tutor, these instructions
MUST be followed:
ƽ WARNING
DO NOT use this equipment without first reading and understanding this
instruction sheet. If you are unable to understand the warnings, cautions and
instructions, contact a healthcare professional, dealer or technical personnel if
applicable, before attempting to install this equipment - otherwise, injury or
damage may occur.
Invacare products are specifically designed and manufactured for use in conjunction
with Invacare accessories. Accessories designed by other manufacturers have not
been tested by Invacare and are not recommended for use with Invacare products.
Assembling the Walking Tutor
Tools required:
• 9/16 Open End Wrench
• 16mm Box End Wrench
• 19mm Box End Wrench
• 13mm Socket Wrench
• 16mm Socket Wrench
• 18mm Socket Wrench
• 5mm Allen Key
• 6mm Allen Key
Attaching Strap Assemblies to the Boom
NOTE: For this procedure, refer to FIGURE 1 on page 2.
1. Remove the boom cover to expose the boom crossbar (Detail “C”).
2. Secure the strap assembly on the crossbar by placing the strap around crossbar and
inserting the buckles through the loop (Detail “A”).
Assembly, Installation and Operating Instructions
SAVE THESE INSTRUCTIONS