Integra DSR-4.8 - Manual (Page 14)

14
Front & Rear Panels—Continued
SPEAKERS [18]
These terminal posts are for connecting your front
speakers.
HDMI IN/OUT [26]
HDMI (High Definition Multimedia Interface) con-
nections carry digital audio and digital video.
The HDMI input is for connecting components with
HDMI outputs. The HDMI output is for connecting
a TV or projector with an HDMI input.
COMPONENT VIDEO OUTPUT [24]
These jacks output component video and can be
connected to an component video input on a TV or
projector.
VIDEO OUTPUT [23]
This RCA connector can be used to connect a TV or
projector with a composite video input.
FM ANTENNA [18]
This jack is for connecting an FM antenna.
AM ANTENNA [19]
These push terminals are for connecting an AM
antenna.
AC INLET [28]
The supplied power cord is connected here. The
other of the power cord should be connected to a
suitable wall outlet.
OPTICAL DIGITAL AUDIO IN [25]
This optical digital audio input can be connected to
an optical digital audio output on a DVD recorder,
or game console.
This input is assigned for VIDEO 1 INPUT in
default.
If you output audio from this input during
VIDEO 2/DOCK INPUT is selected, you must
change the “Video2 Input” setting to “OPT” from
“Coax” (page 54).
COAXIAL DIGITAL AUDIO IN [25]
This coaxial digital audio input can be connected to
a coaxial digital audio output on a DVD recorder or
game console.
This input is assigned for VIDEO 2/DOCK INPUT
in default.
If you output audio from this input during VIDEO 1
INPUT is selected, you must change the “Video1
Input” setting to “Coax” from “OPT” (page 54).
(1
REMOTE CONTROL [25]
This (Remote Interactive) jack can be con-
nected to an jack on Onkyo RI Dock. The DVD
receiver remote controller can then be used to con-
trol the RI Dock. To use
, you must make an
analog audio connection (RCA) between the DVD
receiver and the RI Dock, even if they are connected
digitally.
(2
VIDEO 1 INPUT [24]
Here you can connect other video equipment. Input
jacks include composite video and analog audio
input.
(3
VIDEO 2/DOCK INPUT [25]
Here you can connect Onkyo RI DOCK or other
video equipment. Input jacks include composite
video and analog audio input.
(4
SUBWOOFER PRE OUT [18]
A powered subwoofer can be connected here.
(5
RS232
This port is for connecting the DVD receiver to
external controllers.
(6
IR IN/OUT [27]
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
DVD receiver when it’s out of sight, for example,
installed in a cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals along to other components.
Rear Panel
(3 (1 (2 (4 (5 (6