Invacare 1110154 - Manual

1
TELESCOPING I.V. ROD KIT
Assembly, Installation and Operating Instructions
Kit No. 1110154
SAVE THESE INSTRUCTIONS
NOTE: Check ALL parts for shipping damage. In case of shipping damage, DO NOT use. Contact
Carrier/ Dealer for further instruction.
SAFETY SUMMARY
To ensure the safe installation and adjustment of the Telescoping I.V. Rod Kit,
these instructions MUST be followed:
GENERAL WARNINGS
DO NOT install or use this equipment without first reading and understand-
ing this instruction sheet. If you are unable to understand the Warnings,
Cautions or Instructions, contact a healthcare professional, dealer or techni-
cal personnel before attempting to install this equipment – otherwise, injury
or damage may occur.
DO NOT pull/push the wheelchair by the I.V. rod assembly. Injury to the
assistant/occupant and/or damage to the I.V. rod assembly may occur.
DO NOT place any objects on the I.V. rod assembly other than those deter-
mined by a healthcare professional.
INSTALLATION WARNING
After any adjustments, repair or service and BEFORE use, make sure all
attaching hardware is securely tightened – otherwise injury or damage may
result.
This kit contains the following items:
DESCRIPTION QUANTITY
Telescoping Tube 1
Short Hex Screw 1
Small Locknut 1
Long Hex Screw 1
Large Locknut 1
Adjustment Knob 1
Support Bracket 1
Washer 1
NOTE: The I.V. Rod can be installed to either the right or left side of the wheelchair. The right side
installation is shown in all figures. The left side installs in a similar manner.