InSinkErator Chilled Water Tank & Cold Only Faucet CWT-00 - Manual (Page 2)

Equipment You May Need:
■ ■
IMPORTANT: After unpacking chilled water tank, place the unit upright for 1 hour before
connecting power.
■ ■
For best results, the cold water faucet should be installed prior to installing the chilled water tank.
■ ■
For your satisfaction and safety, read all instructions, cautions, warnings and dangers before installing or
using this chilled water tank.
■ ■
This particular unit is not intended for commercial use.
■ ■
Make sure that all electrical wiring and connections conform to local codes.
■ ■
A standard 120-volt grounded electrical outlet is required under the sink for the chilled water tank’s electrical power.
■ ■
It is recommended that a separate circuit providing power only to the chilled water tank be used.
■ ■
The wall outlet powering the chilled water tank must be fused and should not be controlled by the same wall
switch used by the food waste disposer.
■ ■
It is recommended that a dedicated control valve be installed on the cold water line supplying water to this
system. Make sure all water supply control valves do not have a backflow preventer in them.
■ ■
If you suspect elevated levels of chlorine in your water, it is recommended to use our water filtration system.
■ ■
The water pressure to the chilled water tank should be between a minimum of 30 psi (207kPa) and
a maximum of 100 psi (689kPa).
■ ■
The chilled water tank may cause an increase in temperature in your cabinet when running.
■ ■
The chilled water tank has a refrigeration compressor, which may generate noise while running.
■ ■
The chilled water tank should only be installed in an upright position.
■ ■
The chilled water tank is intended only for chilling water.
WHAT YOU SHOULD KNOW BEFORE YOU BEGIN
Equipment Required:
(sold separately)
■ Cold water faucet
■
T-fitting
■
Dedicated control valve
■
Adjustable wrench
■
Utility knife
■
Tape measure / ruler
If you will be installing a dedicated cold only water faucet and intend to use the sprayer hole in your sink
for that faucet, you may need a basin wrench and a 1/8" plug or a 1/4" hose line cap (not supplied).
If you need to cut a mounting hole in your stainless steel sink, you may need a 1 1 ⁄
4
" - 1 1 ⁄
2
" hole saw made
for cutting stainless steel or a hole punch. Consult a professional if you are drilling into a surface other
than stainless steel.
WHAT YOU NEED TO GET STARTED
■ ■
Hole saw / hole punch
■ ■
Basin wrench
Congratulations on your purchase of this quality InSinkErator ® water product. In addition
to complete operating and care instructions, in this Owner’s Manual you will find instructions
for installing both:
• CWT-00 Chilled Water Tank with an existing hot/cool water dispenser – See pages 4-6
• CWT-00 Chilled Water Tank with a C1100 Cold Only Faucet – See pages 7-9
2