Insignia NS-LTDVD20 - Manual (Page 5)

3
Insignia NS-LTDVD20 20" LCD TV/DVD Combo
www.insignia-products.com
• If your TV combo does not operate normally
by following the operating instructions. Adjust
only those controls that are covered by the
operating instructions because incorrect
adjustment of other controls may result in
damage and will often require extensive work
by a qualified technician to restore your
TV combo to its normal operation.
• If your TV combo has been dropped or
damaged in any way.
• When your TV combo exhibits a distinct
change in performance.
Replacement parts
When replacement parts are required, make
sure that the service technician uses
replacement parts specified by the manufacturer
that have the same characteristics as the
original part. Unauthorized substitutions may
result in fire, electric shock, personal injury, or
other hazards.
Safety check
After completing any service or repair to your
TV combo, ask the service technician to perform
routine safety checks to determine that your
TV combo is in correct operating condition.
Power source
Operate your TV combo only from the type of
power source indicated on the marking label. If
you are not sure of the type power supplied to
your home, consult your TV dealer or local
power company.
Screen protection
Your TV combo’s screen is made of glass. Do
not drop your TV combo or hit the glass screen.
If the screen breaks, be careful of broken glass.
Non-active pixels
The LCD panel contains almost 3 million
thin-film transistors, which provide exceptionally
sharp video quality. Occasionally, a few
non-active pixels may appear on the screen as a
fixed blue, green, or red point. These non-active
pixels do not adversely affect the performance of
your TV combo, and are not considered defects.
Outdoor antenna grounding
If an outside antenna or cable system is
connected to your TV combo, make sure that the
antenna or cable system is grounded to provide
some protection against voltage surges and
built-up static charges. Article 810 of the
National Electrical Code, ANSI/NFPA No. 70,
provides information with respect to correct
grounding of the mast and supporting structure,
grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors,
location of the antenna-discharge unit,
connection to grounding electrodes, and
requirements for the grounding electrode.
An outside antenna system should not be
located near overhead power lines or other
electric light or power circuits, or where it can fall
into such power lines or circuits. When installing
an outside antenna system, extreme care should
be taken to keep from touching such power lines
or circuits, because contact with them can be
fatal.
Note to CATV system installer
This reminder is provided to call the CATV
system installer’s attention to Article 820-40 of
the NEC that provides guidelines for correct
grounding and in particular, specifies that the
cable ground must be connected to the
grounding system of the building as close to the
point of cable entry as practical.
Features
Accessories
Make sure that the following accessories are
provided in the packaging:
•
YPbPr cable
• Power cord
• Remote control and batteries
1 Electric service equipment
2 Power service grounding electrode
system
3 Ground clamps
4 Grounding conductors
5 Antenna discharge unit
6 Grounding clamp
7 Antenna lead-in wire
6
7
5
2 1
3
4