InStep RS100 - Manual (Page 5)

5
To place child in stroller:
Always engage rear brakes so stroller is steady. Lift canopy
from both sides and rotate back. Place child in stroller with
the T-shield between the child’s legs. Fasten the waist buckle.
Adjust belt so that it fits snugly around the child’s waist
(Figure L). (Note: To release, squeeze sides of buckle)
WARNING: Avoid serious injury from falling or sliding
out. Always use seatbelt.
To adjust 3-position recline seat:
To fully recline seat, pull up on the recline bar as shown.
(Figure M) To position seat upright, push back of seat until
side tabs fall into side notches.
WARNING: Child may slip into leg openings and
strangle. Never use in a reclined carriage position unless
T-shield / waist strap have been readjusted to the seats
new position.
For Models CS150T, CS200 and CS300
Child’s Convenience Tray
The napper bar must be used when using the child’s tray.
Step 1. Snap the child’s tray onto both side latches as
shown (Figure N).
Parent’s Convenience Tray
WARNING: To avoid burns, never put hot liquids
in the parent tray. To prevent tipping over do not place
more than 3 lb. or 1.4 kg on parent tray.
Phillips screw driver is required for installation.
Step 1. Fold the tray several times in the hinge area to break
in the hinge (Figure O1).
Step 2. Align the holes on the tray with knob on frame and
snap tray into place over knob. Repeat for other side
(Figure O2).
L
M
N
O2 O1
Tray
Centering
Supports
Side
Clamp
Flex
Hinge
Parent Tray
Knob