Insignia IS-HDPLTV42 - Manual (Page 17)

16
IS-HDPLTV42 42-inch HDTV
www.insignia-products.com
C ONNECTING TO AN ANTENNA
Scrambled and unscrambled
cable 1 Connect the 75-ohm cable from the
cable TV service to a splitter (not
supplied).
2 Connect a 75-ohm cable from the splitter
to the cable converter box input jack,
then connect another 75 ohm cable from
the converter box output jack to the A
jack on an A/B switch box (not supplied).
3 Connect a 75-ohm cable from the splitter
to the B jack on the A/B switch box.
4 Connect the A/B switch box to the
VHF/UHF jack on the back of your
HD TV
5 To watch scrambled channels, set the
switch box to the A position, set your
HD TV to the output channel of the
converter box (usually 3 or 4), then use
the converter box or satellite box to
select channels.
Or
To watch unscrambled channels, set the
switch box to the B position, then use
your HD TV remote control to tune
channels.
Cable type Connection description
75-ohm
antenna
connector
75-ohm coaxial
cable
Twin lead feeder
(300-ohm)
Loosen the
screw Insert the
feeder Tighten the
screw