Connecting your monitor – IBM L170 User Manual
Page 9
6
Connecting your Monitor
Be sure to read the 'Safety'
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
1.
Turn off your computer and all attached devices.
2.
Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card might be blue to match the blue
connector on your monitor’s video cable.
3.
The supplied power cord is not attached to the monitor. If you would like
to route the power cord through the stand, follow the instructions below:
a. Tilt the monitor all the way forward.
b. Hold the top of the cable cover (a) and pull it off.
c. Gently lift the stand cover (b) and slide it backwards and off the stand.
b
a
forward tilt